Home › Forums › Software Development › Can not specify the eye tracker using URL
- This topic has 5 replies, 4 voices, and was last updated 9 years, 5 months ago by Robert [Tobii].
- AuthorPosts
- 06/11/2014 at 15:22 #1978yazhangParticipant
I would like to specify different eye trackers to start based on their URL. I have used “tet-usb://<serial number>” format but it doesn’t connect to the eye tracker. It can only recognize a TCP/IP format with local host address. The application I am running is the “MinimalTrackerNet” sample application. Any advice? Many thanks.
06/11/2014 at 15:47 #1980AndersParticipantHi yazhang,
are you using the Gaze SDK or the EyeX SDK? And what eye tracker models are you using?06/11/2014 at 15:56 #1981yazhangParticipantI am using the GazeSDK and the EyeX controller.
07/11/2014 at 12:29 #1985AndersParticipantRight. The EyeX controller is a bit of a special case. It’s only possible to connect one of those to the computer at any time and it’s hard wired to use the tet-tcp protocol.
If you need to connect multiple trackers to the computer, the only tracker model that supports this at the moment is the REX.
08/11/2014 at 07:06 #1990Curtis NixonParticipantHow this tracker model “REX” is been supported..? and how it is been connected..?
10/11/2014 at 09:33 #1997Robert [Tobii]ParticipantThe Tobii REX eye tracker can be used with the Gaze SDK or EyeX SDK. It only requires USB 2.0 but is much more expensive. Read more about Tobii REX.
- AuthorPosts
- You must be logged in to reply to this topic.